Match and Stitch o
nly matches, it doesn’t stitch
Is it possible to clear the SEAM when stitching?
Hey. There are several reasons why you might not see the stitching result.
- Reason number one: You haven’t enabled the Stitch option. This is a complex operation, and stitching isn’t always possible. That’s why you should first perform a Match, and if you’re satisfied with the alignment, enable Stitch. I’ll address the “clear sem” issue right away. At the moment, this option has not been considered due to the complexity of the operator. But we have plans for optimization, so it is possible that this option will be added.
- Reason 2: You are working in Sticky Selection Mode - Disabled. In this mode, you cannot select multiple vertices with a single click. Switch to Shared Location.
Thank you for your reply
1 Like